Davenports Locksmith & Roadside Service
906 Brighton St Paragould, Arkansas 72450
(870) 239-5803
Davenports Locksmith & Roadside Service
Handy Tips For A Jump-Start In Jonesboro

Handy Tips For A Jump-Start In Jonesboro

Having to jump-start a car generally means that something has gone wrong and that the car isn't functioning as it should for some reason. All too often, when a car decides to fail, it happens at the most inconvenient time: like while you're pulled over on the side of the road--after all, when's the last time you saw someone trying to jump a car that was sitting in their driveway? This puts people in an unfamiliar situation, in a place that they're generally not comfortable being in. As each one of these variables begins to compound, it can be hard to get a grip on the situation: often times people forget about minor details that can be important to remember when jumping a car.

Here are a few handy tips to keep in mind when you’re facing a jump-start in Jonesboro:

Safety First: No matter where you may be or how flustered the situation may make you, never, ever forget about all of the safety precautions that you should take when jumping a car. All it takes is one wrong hand placement and you could get a nice little jolt down your body! Always remember to insulate your hands before touching the jumper cables to any part of the car and be aware of each different component throughout the process. Moreover, pay attention to traffic as well! People often forget that while they’re stuck under the hood of their car, there are other motorists whizzing along beside them. Forgetting your place and taking a step in the wrong direction could put you in danger.

Find a Good Ground: Grounding the circuit is essential in the jumping process and should be the first thing that you do when the clamps come out. A jump-start in Jonesboro isn’t going to work if there’s no ground, so picking one that’s away from potential conductors is your best bet. A good ground will do more than just breathe life back into your vehicle, however, it’ll also prevent a potential disaster. If you’re careless with your ground, it could emit a spark when the circuit is closed: a spark that may not play well with all of the chemicals under your hood. Picking a non-working part of the car that’s situated away from the battery will go a long way towards expediting the jumping process and ensuring your safety.

Don’t Turn Off The Car: As you very well may know, a jump-start in Jonesboro requires two cars: the jumper and the jumpee. The juice from one car will act to supercharge the battery in the other, allowing both cars to be on their merry way. While jumping a dead battery, it’s important that the jumper leave their car on throughout the entire process, to make sure that the battery in the jumpee is fully charged. Cutting power in the midst of a jump could make you have to restart the process or worse yet, kill all hope of a jump in the first place! Only after the jump is complete should either of the cars be turned off and it’s best to drive for a few miles before doing so.

Post Tags:Roadside

Add a Comment

* Fields marked with an asterisk are required.